OUR MASKS

Features

Medical Masks

ASTM F2100-19 Level 2 and 3 Masks

Our masks have to go through and pass rigorous, high-stress testing to comply with protocols set by ASTM guidelines. 

Nose Bridge

Our superior nose bridge contours your cheeks creating a  barrier to help combat fog, white keeping our airborne particles

Super Soft Fabric

Our materials not only have a super soft inner layer, but a soft cashmere look and feel outer layer.

Ear Loops

Ticker, flatter and a tad longer ear loops to aid with ear discomfort and fatigue. We have our ear loops on the front of our mask, so you don't have to worry about skin irritation.

3 Layer, 3-Ply Protection

Outside: Blocks Droplets with Spunbond Polyester

Middle: Filters Out Particles with Meltblown Polypropylene

Inner: Optimal Breathability with Spunbond Polypropylene

Designed, Made and Tested in Canada

Our factory is based in Burnaby, BC.

Health Canada Medical Devices License 15095 (MDEL)

We hold a MDEL issued by Health Canada who sets requirements, enforces compliance and monitors safety.

Bacterial and Particle Filtration Efficiency

Our masks start at ≥ 98% efficiency. That is important because our mask's resistance to bacteria starts at 98% and only gets better. 

And our filtration of particles is a minimum of 98% and goes up. 

Fluid Resistance

ASTM requires Level 1 Masks to resist droplets at 80 mmHg.

Level 2 Masks to resist 50% more droplets at 120 mmHg.

And Level 3 Masks at 100% more at 160 mmHg. 

Our masks start at Level 2, which are 50% more resistant than level 1. 

Breathability

Delta P Differential Pressure tests how easy it is for air to pass from the outside-to-inside the mask and vice versa.

Our mask are < 6.0 mm H20.